Start chat!
Chat accepted!
Sorry, the chat is not available at this moment.

Skip to Main Content »

Worlds First Condom Speciality Shop
 

You have no items in your shopping cart.

Language

You're currently on:

Condom Leaktest Machine

Condoms are filled with a salt solution and then electrically tested to check if there are any holes in the rubber.

Electric current detects leaks

How are condoms tested?

Condom leak tester (ElectroLyte WaterTesting)

De eerste condoom lektest machine is ontwikkeld door TNO KRI delft. De machine staat tegenwoordig in de Condomerie in Amsterdam. De methode van 'ElectroLyte WaterTesting' in een zoutoplossing wordt nog steeds door condoomfabricanten wereldwijd gehanteerd om condooms te testen op (onzichtbare) lekken.

Jaap Havinga, engineer and rubber specialist at bij TNO: "Obviously, a condom should stay intact during use. Hence, the burst test is an important step in condom testing." The condom is placed on a base and inflated. It is rather like blowing up a balloon, only the air is introduced more quickly and more evenly. Depending on its size, a condom should hold 16 to 22 litres. "But most condoms will take up to 30 litres of air. It's only the ultrathin ones which have a capacity only slightly higher than the standard requires. Condoms should be able to withstand a pressure of 0.1 bar without failing. For comparison: the pressure in a car tyre is usually above two bar."

The same test is applied to condoms which have been subjected to accelerated ageing by placing them in an oven for a week. This is important because condoms are sometimes exposed to extreme conditions, especially during transport. The packaging is also tested to ensure that it provides adequate shelf life. Condoms should have a shelf life of at least five years.

There is also the "freedom from holes" test. This demonstrates that a condom does not leak. Havinga explained: "The condoms are filled with a salt solution and suspended in a bath filled with the same solution. Electrodes are placed inside and outside the condom, and a voltage is applied across them. If a current flows between the electrodes then the condom may be leaking. This is because the salt solution conducts electricity. If a current is detected, then a second straightforward leak test is used. The condom is then filled with 300 ml water. If the filled condom stays dry on the outside then it is rolled across blotting paper, with some force. If the paper stays dry then the condom meets the requirements. Otherwise it doesn't." Source: Quest 12/2005
Animation by Benjamin van Gogh

Photography by: Theodoor van Boven (Condomerie)


Text on image above (text on the side of the unit)
Leak tester modifications
The red tank and the 10 solenoid-operated valves at the top are no longer used.

Operation

  1. Fill the grey tank at the bottom with the water/salt solution.
  2. Switch manually to "Fill"
    First purge the system to eliminate air from the pump.
    Repeat several times, until water flows from all 10 tubes.
  3. Set switch to "Automatic".
    Place the condoms and fill them.


Text on image above (text on the side of the unit)
Instructions for use

Leak tester, fill with 75 l water then add 750 g ordinary salt.
1% NaCl solution

About the newsletter
When you subscribe, you will receive our Mailchimp newsletter approx. 6 times a year. Every letter contains an unsubscribe link. Or contact us and we will arrange it for you.
 
About Us

The Condomerie is the first condom speciality shop in the world. Founded in 1987 in Amsterdam.

kvk. 33193870.

VAT NL0086.82.033.b01.

  •   Warmoesstraat 141
    1012JB Amsterdam, The Netherlands
  •   +31 (0) 20 6274174
Follow Us

Follow us on social media:

Newsletter